Boat Trailer Wiring Diagram

Hi, need to wire up an old boat trailer with new cable as the old cable has been removed. Preferably an actual diagram. Wider than 2m meters so needs marker lamps as well. Thks
For New Zealand

Don't know if you have Repco in Un Zud - over here in Oz there are complete LED kits for Au $100 at the moment.

http://www.prescotttrailers.co.nz/traile r_plug_wiring.html

http://www.campertrailers.org/trailer_wi ring_diagram.htm

http://www.reidtrailers.co.nz/info/info. html

2009-08-09 00:48:07 by Mike

Make sure you put the right lamp on the right side when rewiring trailer lights. Learn how to rewire trailer lights in these free trailer wiring ...

Anyone have a wiring harness location (Diagram) for a t-connector on a 2004 chevrolet Malibu classic , I want to install a flat four connector for a boat trailer and can’t find it.

If you have one, it would be in the trunk, under the mat; unless your car came from the factory with a tow prep package, plan on splicing in a universal connector, wire by wire. You also might try looking up behind the rear bumper. My 2000 Blazer has a harness, but no plug.

2009-08-21 16:37:37 by Randy

Price: $5.95 $5.95

Heres what i know right know. The green wire controls the right stop and turn. The yellow controls the left stop and turn. The brown controls the tailights. The white is the ground wire.
I checked to make sure power is gioing to the tailights when the switch is on, likewise with the other wires.
Now i have been having trouble getting the taillights to work. And if i get the tailights to work, when i wiggle the 4 way connector, touching the break pedal makes everything go off. I already made sure the ground is secured in a good location.

My questions are then:
Is the brown and yellow wires suppose to be connected to the break bulb and if they are how is the break bulg grounded?

Is only the smaller light suppose to be on when just the tailights are on?

What lights all have to have the ground wire connected to them?

Is there a good wiring diagram that can help me out here to give me more detail than what i already know?

Brown is your parking or headlight circuit
White is your ground
Green is your right turn signal
yellow is the left turn signal
Each lamp where its mounted has its own ground.
Take your white wire and secure it with a ring terminal to a bolt somewhere on the coupler .When you turn on the headlights the brown wire should activate sidemarkers and tailamps
When you use brakes both green and yellow wires are hot and should work the brake light
When you put on say left turn signal yellow wire gets its current and flashes the marker on that side and the same for the other side right activates current in green and makes light flash
Hope this helps

2007-05-20 12:53:11 by adam f

Price: $49.99 $22.30

Molded with plastic weather proof case
1.5-amp charger
Has reverse polarity protection