The Boat Log .com

Johnson Boat Motor Manual


Johnson Outdoors

Boat Motors


Minn Kota Endura C2 30 Freshwater Transom Mounted Trolling Motor (30" Shaft)
(Sports) Johnson Outdoors
Release date: 2010-10-01

5 forward speeds, 3 reverse speeds for maximum control
Indestructible composite shaft backed my a lifetime warranty; two year warranty covers the motor
6-inch telescoping handle and tilt twist tiller for ergonomic speed control and steering; lever lock bracket offers a rock solid mount


Price: $110.99 $99.00

Answers

where can I find an owners manual for a 2003 johnson 40hp boat motor?

Bought the boat in 2005, but didn't get an owner's manual for the motor.Needs some work on it.......runs sporadically.Would like to rebuild it.


probably just needs a carb rebuild.

manuals are available at
http://www.iboats.com
http://www.marineengine.com
http://www.kencook.com

I highly recommend the factory shop manual.

(FOR SALE) Running Johnson 6hp Outboard boat engine after being stored & winterized.


Running Johnson 6hp (6 Horse Power) 2 cycle (2 stroke, two stroke) outboard boat engine in neutral after being stored & winterized. It is ...

What power tilt trim setups will work with a 1975 75hp Johnson Stinger 2 Boat Motor?

I have a manual tilt Johnson 1975 (possibly 1976) 75hp Stinger 2 (it was originally orange) boat motor. I'm looking to add a used power tilt/trim setup to make things much easier. What all do I need and what models and years of Johnson/Evinrude will interchange so it will be a direct bolt up?
so just to clarify, I need one from a 1975-1979 3cyl johnson.


Any 3-cylinder through 1979 will work. Later models, I can't say for sure. Earlier than 1975, don't know about those, either.

Before 1980 OMC sold a power tilt unit as a dealer-installed accessory (I have one), it's power tilt only, not trim. Way better than nothing, but power trim would be nice.

A new aftermarket unit will cost you several times the value of the motor; bet you can find one with a blown powerhead.

Minn Kota Endura C2 40 Freshwater Transom Mounted Trolling Motor (36" Shaft)
Johnson Outdoors

Price: $176.99

12-volt freshwater transom-mounted trolling motor with a thrust level of 40 and a 36-inch shaft
Cool quiet power maximizes battery life and doesn't spook fish
5 forward speeds, 3 reverse speeds for maximum control

1969 Johnson 20hp boat motor,model # 20R69D. What is the fuel mix ratio?

I recently aquired a boat with a Johnson 1969 20hp motor and have no idea what the fuel mix ratio is. I want to be sure before I start it and there are no manuals that came with it. Is it 50:1?


hi there
you should most definitly use a 50:1 mix J/E changed to this ratio in the 60's and was the best thing they done. A good general rule of thumb to remember the ratio is to figure 1 pint 16 oz. of oil to 6 gallons of gas. Also you want to put oil in tank first to make sure it is mixed up with gas properly. Hope this helps u out.

Johnson/Evinrude Outboards, 1973-91 Repair Manual, Covers all 60-235 HP, 3-Cylinder, V4 and V6, 2-Stroke Models, Includes Jet Drives (Seloc)
Seloc Publishing

Price: $38.95

Step-by-step illustrated keyed procedures serve as a detailed guide through the complete job, including necessary adjustments.
Dozens of exploded line drawings.
Detailed wiring diagrams.

How can I find how to instructions for boat motor repair online for free?

Trying to repair a 1985 Johnson 300hp boat motor and need intructions and trying to find online for free so don't have to buy manual but all I can find is manuals for sale so thinking maybe looking in wrong places so was hoping someone out there would know where/how to look. Thanks.


good luck, only thing i have found is an online parts cat for omc. you can get a repair manual on ebay for about $25, try www.epc.brp.com

I need an electric tilt-trim set-up for an older model johnson 115 hp boat motor. Where can I find one?

The one I have is manual and it makes the boat hard to launch.


you can order almost anything off the puter these days but the best thing to do is old fashioned shopping around your home town.


  • Buy Cheap

  • Evinrude Boat Motor

    I own an Evinrude Lark 35hp boat motor that has no battery. I can't get it to turn over by priming it and pulling the starter cable. I need someone who really knows their stuff for this one. I need to know if I'm doing everything correctly and if there's something wrong with the motor. If something's wrong, I need help troubleshooting.


    The Lark was a magneto ignition. You need the key to stop it, not to start it. So be ready for what you wish for. Next they had a mercury kill switch on the throttle handle. So if you over throttle it, it won't start. Some had an automatic choke.(Not the electric switched pull down, but a real auto choke like an old chevy) It didn't work, set choke on manual. That said, do you have spark--with key disconnected or "On". Is any fuel getting to the plugs? Take one out and see if it is wet.. Is the engine still in a running condition--ie. does it have any compression. At least 80# but more important - are they very close to the same. Did you ever run it out of the water. If so It will need a water pump. Only one way to effectively clean a carb: remove, disassemble, soak the metal parts overnight in carb cleaner, blow out all passages with compressed air (or aerosol carb cleaner), reassemble with new carb kits, reinstall, link & sync. Your carbs have fixed jets, no mixture screws to mess with.

    ...

    Read more...

    News

    July, August 2010: Storms, murder charges, Purple Hearts highlight

    Lakeland Times - Jan 04, 2011

    Johnson, 25, of Woodruff, was charged Monday, Aug. 23, with homicide by negligent use of a motor vehicle, five felony counts of injury by negligent handling and more »